It is very necessary to realize that according to the PPL reissue MSHA inspectors will evaluate the situation for "a danger of falling" The Operator must examine all working places to make certain that "there are no unprotected sides or edges which are 6 feet or more above a lower level" as required in the OSHA standard. Any site that has not "Fall-proofed" as per the OSHA standard will have given the inspector another "MSHA Gotcha"!

$afepro

 

U.S. Department of Labor
Mine Safety and Health Administration
1100 Wilson Boulevard
Arlington, Virginia 22209-3939 EFFECTIVE DATE: March 25, 2014 EXPIRATION DATE: 3/31/2016


PROGRAM POLICY LETTER NO. P14-IV-02
FROM: MARVIN LICHTENFELS
Acting Administrator for Metal and Nonmetal
Mine Safety and Health
SUBJECT: Reissue of P12-IV-01 Safety Belts and Lines (30 C.F.R. §§ 56/57.15005)
Scope
This Program Policy Letter (PPL) applies to surface and underground metal and nonmetal mine operators, contractors, equipment manufacturers, miners, miners' representatives, and Metal and Nonmetal Mine Safety and Health enforcement personnel.
Purpose
The purpose of this PPL is to clarify compliance with safety belts and lines as required under
30 C.F.R. §§ 56/57.15005 to enhance consistency and protection of miners.

Policy
MSHA standards at 30 C.F.R. §§ 56/57.15005 require that safety belts and lines be worn when persons work where there is danger of falling; a second person must tend the lifeline when bins, tanks or other dangerous areas are entered. The Occupational Safety and Health Administration's (OSHA's) fall protection standard at 29 C.F.R. §1926.501(b)(1), Unprotected sides and edges, states that "Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems." In many cases, compliance with OSHA's fall protection standard will satisfy the requirements of MSHA's 30 C.F.R. §§ 56/57.15005 standard. MSHA will evaluate all work area hazards to ensure appropriate fall protection provisions are in place to protect miners from fall hazards.

Background
This policy letter clarifies the Agency's application of 30 C.F.R. §§ 56/57.15005, Safety belts and lines. Operators have raised questions regarding what factors MSHA takes into consideration when applying §§ 56/57.15005.
Authority
The Federal Mine Safety and Health Act of 1977, as amended, 30 U.S.C. § 801 et seq.; 30 C.F.R. §§ 56/57.15005.
Internet Availability
This program policy letter may be viewed on the World Wide Web by accessing the MSHA home page (http://www.msha.gov) and by choosing "Compliance Info" and "Program Policy Letters."
Issuing Office and Contact Person
Metal and Nonmetal Mine Safety and Health
Chief, Safety Division
Brian Goepfert, (202) 693-9600
E-mail address: goepfert.brian@dol.gov
Distribution
MSHA Program Policy Holders
Underground and Surface Mine Operators
Underground and Surface Independent Contractors
Special Interest Groups
Miners' Representatives